Browse Resources

This video from CUNY Kingsborough Community College describes the parts of a micropipette. The demonstrator describes each part of the device and what it is used for. Running time for the video is 2:45.

This video from CUNY Kingsborough Community College describes how to perform a gram strain. The brief demonstration is described step by step and would be easy to replicate in a laboratory setting. Running time for the video is 1:46.

This video from CUNY Kingsborough Community College describes the process of pipetting. The brief demonstration is described step by step and would be easy to replicate in a laboratory setting. Running time for the video is 2:27.

This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Steve Brown demonstrates preparation for creating the guitar body contours and determining where not to sand or cut (the no...

This video from CUNY Kingsborough Community College shows how to pour an Agarose Gel. The video describes the process step by step and would be easy to replicate in a laboratory setting. Running time for the video is 2:13.

This video from CUNY Kingsborough Community College describes the technique of preparing to pour an Agarose Gel. The video describes the process step by step and would be easy to replicate in a laboratory setting. Running time for the video is 3:22.

This video from CUNY Kingsborough Community College describes the technique of preparing an Agarose Gel. The video describes the process step by step and would be easy to replicate in a laboratory setting. Running time for the video is 3:10.

This video, published by the National Center for Optics and Photonics Education (OP-TEC), is from module one of the Quality Assurance of Precision Optics course, which "provides an introduction to quality assurance practices required to identify, inspect, and measure optical components." During the...

This video, from the LEAD with Guitars in STEM project, demonstrates the process of leveling uneven guitar frets using a radius beam covered with sandpaper. The host, Doug Hunt, explains how to prepare the frets and fret board using masking tape and a permanent marker before demonstrating the...

This video, from the North Dakota State College of Science, features the work of Ross Nanotechnology, a company which uses superhydrophobic technology. The video demonstration will help to facilitate discussion about how companies use this type of technology to create products as well as the...