Browse Resources

Lesson Description: In this lesson, provided by the Contextualize to Learn project at the University of Wisconsin-Madison, students learn about and create a Bill of Materials (BOM). Students should understand the following five objectives after completing the lesson: That all Bills of Material...

This 4-page course outcome summary, published by Northeast Wisconsin Technical College (NWTC), provides information on the learning outcomes from the Blueprint Reading Intro course offered by NWTC. Blueprint Reading Intro teaches students the necessary knowledge and skills to understand aspects of...

This video recording, from Excelsior College, takes users through a blueprint simulation. The simulation involves "an electrician troubleshoot[ing] a defective compressor motor that will not start." Appropriate blueprints are selected "that must be referred to while performing the troubleshooting...

This video recording, from Excelsior College, takes users through a blueprint simulation. The simulation involves "an electrician troubleshoot[ing] a defective water pump that will not start." Appropriate blueprints are selected "that must be referred to while performing the troubleshooting steps."...

This 25-page report, published by Universidad de Ingeniería y Tecnología, describes the design and construction of the underwater remotely operated vehicle (ROV) created by Blume Team for the Explorer Class of the 2022 MATE ROV competition. MATE ROV is a global competition that challenges STEM...

This video, published by Blue Mountain Community College, provides an introduction to variable rate application. Employees in various aspects of the agricultural industry discuss relevant equipment and technology. Tractors are shown applying chemicals in agricultural fields using the technique, and...

This video is a tank and engine animation of the BMW Hydrogen 7 car. The video is 3 minutes and 18 seconds in length.

This site includes an interactive Java applet for control systems. Users may drag open-loop corner frequencies with the mouse to improve tracking performance and reject sensor noise in a unity-feedback system.

This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Steve Brown introduces hand and power tools used to shape wooden guitar bodies. Tools introduced include: an angle grinder,...

This animation, created by faculty at Dartmouth University, is a boost converter. The resource features other animations including buck and discontinuous converters. The site also depicts simple diode, bridge, and half-wave with cap rectifiers.