Browse Resources

This collection is provided by the Center for Advanced Automotive Technology (CAAT) and includes four PDF presentations that were given at the 2018 Electric-Drive Vehicle Technology workshop. The workshop was created by Wayne State University to familiarize automotive instructors on current industry...

This presentation by Louise Yarnall of SRI International was given to the Workshop on Assessment of 21st Century Skills, held in January 2011. In it, Yarnall discusses STEM workforce growth areas, how the technicians that will fill these jobs are taught, skills that employers seek, and a new vision...

This presentation, created by Louise Yarnall of SRI International, discusses a scenario-based learning approach for teaching STEM technical education. The presentation discusses the following topics: STEM workforce growth areas, how technicians are taught, skills employers seek, a new vision for...

This lecture, published by Columbia Gorge Community College, discusses the "the analysis of balanced and unbalanced 4 wire y configurations, 3 wire y configurations, and delta configurations in 3 phase AC systems." The recording runs 16:36 minutes in length and part two is available to view...

This lecture, published by Columbia Gorge Community College, discusses the "the analysis of balanced and unbalanced 4 wire y configurations, 3 wire y configurations, and delta configurations in 3 phase AC systems." The recording runs 18:15 minutes in length and part one is available to view...

This lecture, published by Columbia Gorge Community College, shows how to "power factor correct a 3 phase AC 3 wire y configured induction motor." The recording runs 5:36 minutes in length and part two is available to view separately.

This lecture, published by Columbia Gorge Community College, shows how to "power factor correct a 3 phase AC 3 wire y configured induction motor." The recording runs 7:20 minutes in length and part one is available to view separately.

This lecture, published by Columbia Gorge Community College, demonstrates the use of "the three wattmeter, the single wattmeter, and the two wattmeter method to measure power in a balanced three wire y configured motor." The recording runs 5:47 minutes in length and part two is available to view...

This lecture, published by Columbia Gorge Community College, demonstrates the use of "the three wattmeter, the single wattmeter, and the two wattmeter method to measure power in a balanced three wire y configured motor." The recording runs 5:56 minutes in length and part one is available to view...

These presentation slides are provided by Edmonds Community College and are intended to use with the 3-D Spatial Visualization Skill Building for Additive Manufacturing activity. The slides include a blank KWLD Chart; a 2-D Cartesian Coordinate System image; a 3-D X, Y, Z-Axis diagram; a...