Browse Resources
Resources | |
---|---|
This site, from the Imperial College, London, Department of Computing, presents the Free Online Dictionary of Computing, which includes "definitions of acronyms, jargon, programming languages, tools, architecture, operating systems, networking, theory, conventions, standards, mathematics, telecoms,...
This webpage provides information about FreeCAD, a general purpose parametric 3D computer-aided design (CAD) modeler. FreeCAD is primarily for designing real-life objects and is intended for home users/hobbyists, experienced CAD users, programmers, and educators. "FreeCAD is aimed directly at...
This resource, published by Erie Community College, consists of three videos that demonstrate the use of a Rough Vacuum Equipment Trainer (RVET) to freeze water at room temperature. In the first part, the presenter provides instruction on the correct setup of the RVET, including valve positions and...
This video, made available by the Northeast Advanced Technological Education Center (NEATEC), is part of the NEATEC Electronics II Series from Professor Roger Young. This video describes frequency and runs 12:34 minutes in length.
Mike Qaissaunee, an Associate Professor of Engineering and Technology at Brookdale Community College, is the author of this blog and "shares his experiences and perspectives on integrating new technologies in and approaches to teaching and learning." Qaissaunee's blog, titled "Frequently Asked Q,"...
This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Alex Moll demonstrates preparation of the fretboard for fret installation during electric guitar construction. The video...
This video, made available by the STEM Guitar Project, is a demonstration of alignment of the fretboard for proper scale length during electric guitar construction. In the video Chad McCormack describes the entire process in detail throughout the demonstration. The recording runs 5:01 minutes in...
This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Steve Brown demonstrates fret installation during electric guitar construction. The video runs 8:08 minutes in length and...
This webinar, published by the Wake Forest University School of Medicine, includes three short presentations that connect practical aspects of regenerative medicine curriculum to the training of the future biotechnology workforce, followed by a panel discussion. In the first presentation, Jim...
This 13-page business brief summarizes research on companies that are benefiting financially by investing efforts and resources in lower-wage employee development. This brief includes the following sections: The Case in Brief: Why Invest in Lower-Wage Workers?, Pulling Together for Better Results,...
| |
← Previous | Next → |